PK-232 MBX – OPERATING MANUAL MAILDROP OPERATION
8/91 5-4 70
E Shows the following short help file:
E msg#
E msg# B/T/P
E msg# Y/N/F
E msg# >/</@ callsign
E 12 Shows message 12's info line
E 23 > W0RM Sets "W0RM" as message 23's destination
E 35 < WH1Z Sets "WH1Z" as message 35's source
E 48 @ N7ML Sets "N7ML" as message 48's destination BBS
E 49 @ N7ML.MT.NA Sets "N7ML" as message 49's destination BBS and adds the
hierarchical forwarding information .MT.NA signifying that
N7ML BBS is located in the state of Montana (MT) which is lo-
cated in North America (NA)
E 58 @ Clears message 58's destination BBS field
E 60 P Sets message 60's status to Private
E 61 B Sets message 61's status to Bulletin
E 62 T Sets message 62's status to Traffic
E 63 Y Sets message 63's status to Has-Been-Read
E 64 N Sets message 64's status to Has-Not-Been-Read
E 49 F Sets message 49's status to Reverse Forward
The command "E n F" sets the message status to enable Reverse Forwarding of a mes-
sage number. To cancel forwarding, set the status to either "Y" or "N". Please read the
section on Reverse Forwarding (below) if you are interested in this feature.
5.4.4 (HELP) (Remote only command)
The "H" command sends the distant station a HELP list of all available MailDrop com-
mands as shown below. The "?" will also cause the HELP file to be sent.
A(bort) Stop Read or List
B(ye) Log off
H(elp) Display this message
J(log) Display stations heard
K(ill) K n : Kill message number n
KM : Kill messages you have read
L(ist) L : List message titles
LM : List messages to you
R(ead) R n : Read message number n
RM : Read all your unread messages
S(end) S : Send a message to SYSOP
S n : Send a message to station n
V(ersion) Display TNC firmware version
? Same as H(elp)
5.4.5 J (JLOG) (Remote only command)
The "J" command sent by the distant station will cause your MailDrop to send the PK-
232's MHEARD List to the station. This command is not available to you the SYSOP since
you can simply enter MHEARD at the PK-232 command prompt.
To Next Page
Loading...