PK-232 – MBX OPERATING MANUAL COMMAND SUMMARY
4/91 A-24 149
CHCall ON|OFF Default: OFF
Mode: Packet Host: CB
Parameters: ON - Call sign of the distant station IS displayed in multiple connection Packet
operation.
OFF - Call sign of the distant station is NOT displayed (default).
With CHCALL ON, the call signs of the distant stations appear after the channel identifier when you
are connected to more than one Packet station. When CHCALL is OFF, only the channel number is
displayed in multiple connection operation.
When CHCALL is OFF, the monitored activity looks like this:
:0hi John
hello Mike how goes it?
:1*** CONNECTED to N7GMF
:1must be a dx record. ge John
When CHCALL is ON, the same contact has the additional underlined information:
:0:N7ML:hi John
hello Mike how goes it?
:1:N7GMF:*** CONNECTED to N7GMF
:1must be a dx record. ge John
CHDouble ON|OFF Default: OFF
Mode: Packet Host: CD
Parameters: ON - Received CHSWITCH characters appear twice (doubled).
OFF - Received CHSWITCH characters appear once (not doubled).
CHDOUBLE ON displays received CHSWITCH characters as doubled characters.
Set CHDOUBLE ON when operating with multiple connections to tell the difference between
CHSWITCH characters received from other stations and CHSWITCH characters generated by your
PK-232. In the following example CHDOUBLE is ON and CHSWITCH is set to "|" ($7C):
|| this is a test.
The sending station actually transmitted:
| this is a test.
The same frame received with CHDOUBLE OFF would be displayed as:
| this is a test.
CHeck "n" Default: 30 (300 sec.)
Mode: Packet Host: CK
Parameters: "n" - 0 to 250 specifies the check time in ten-second intervals.
0 (Zero) disables this feature.
CHECK sets a time-out value for a packet connection if the distant station has not been heard from
for CHECK times 10 seconds.
To Next Page
Loading...