PK-232 – MBX OPERATING MANUAL COMMAND SUMMARY
4/91 A-57 182
You can include optional SSIDs specified as "-n" after the call sign. If MTO is set to "NO N6IA," any
combination N6IA-0,...N6IA-15 will NOT be monitored. If MTO is set to "YES N6IA-1," then only
N6IA-1 will be monitored.
When MFROM and MTO contain different arguments, the following priority applies:
1. ALL, 2. NO_list, 3. YES_list, 4. NONE
Clear MTO with %, & or OFF as arguments.
MWeight "n" Default: 10
Mode: All except Packet Host: Mw
Parameters: "n" - 5 to 15, specifies roughly 10 times the ratio of one dot length to one inter-el-
ement space length in transmitted Morse code.
A value of 10 results in a 1:1 dot-space ratio. A setting of 5 results in a 0.5:1 ratio, while a setting
of 15 (maximum) results in a 1.5:1 ratio.
MWEIGHT applies only to the Morse transmit mode and the CW ID in all modes except packet.
MWEIGHT does not affect the code output by the MID command.
MXmit ON|OFF Default: OFF
Mode: Packet Host: Mx
Parameters: ON - Monitor transmitted packets in the same manner as received packets.
OFF - Do not monitor transmitted packets.
When MXMIT is ON, transmitted packets are monitored in the same manner as received packets.
The monitoring of transmitted packets is subject to the settings of MONITOR, MCON, MFROM,
MTO, MRPT and TRACE. Most transmitted packets occur during connections so MCON should prob-
ably be set to a non-zero value.
MYAlias call[-n] Default: none
Mode: Packet Host: MA
Parameters: call - Alternate packet digipeater identity of your PK-232
"n" - 0 to 15, an optional substation ID (SSID)
MYALIAS specifies an alternate call sign (in addition to the call sign specified in MYCALL) for use as
a digipeater only. In some areas wide-coverage digipeater operators change their call sign to a
shorter and easier to remember identifier.
MYALTcal aaaa Default: none
Mode: AMTOR Host: MK
Parameters: aaaa - Your alternate SELective CALling code (SELCALL)
To Next Page
Loading...