PK-232 – MBX OPERATING MANUAL COMMAND SUMMARY
4/91 A-70 195
RESET Immediate Command
Mode: Command Host: RS
RESET is an immediate command that resets all parameters to PK-232's PROM default settings and
reinitializes the PK-232. All personalized parameters, monitor lists and MailDrop messages will be
lost.
RESptime "n" Default: 0 (000 msec.)
Mode: Packet Host: RP
Parameters: "n" - 0 to 250 specifies 100-millisecond intervals.
RESPTIME adds a minimum delay before your PK-232 sends acknowledgment packets. This delay
may run concurrently with the default wait time set by DWAIT and any random wait in effect.
During a file transfer, RESPTIME can help avoid data/ack collisions caused by the sending stations
TNC pausing briefly between transmitted data frames.
RESTART Immediate Command
Mode: Command Host: RT
RESTART is an immediate command that reinitializes the PK-232 while retaining the user's settings.
The effect of the RESTART command is the same as turning the PK-232 OFF, then ON again.
RESTART does not reset the values in bbRAM. See the RESET command.
REtry "n" Default: 10
Mode: Packet Host: RY
Parameters: "n" - 0 to 15 specifies the maximum number of packet-retries.
The AX.25 protocol uses the retransmission of frames that have not been acknowledged as a
means to insure that ALL transmitted frames are received. The number of retries that the PK-232
will attempt is set by the RETRY command (default 10). If the number of retries is exceeded, the
packet link may be lost.
RFec ON|OFF Default: ON
Mode: AMTOR Host: RF
Parameters: ON - Mode B (FEC) signals are displayed in AMTOR Standby (default).
OFF - Mode B (FEC) signals are not displayed in AMTOR Standby.
Turn the RFEC command OFF to prevent the reception and display of all FEC signals received while
in AMTOR Standby.
To Next Page
Loading...