PK-232 MBX – OPERATING MANUAL COMPUTER INSTALLATION
4/91 2-7 22
If you have gotten this far then the digital section of the PK-232 and the VHF mo-
dem are both working.
15. We will now check the PK-232s HF modem. If you are using an AEA program, follow
the instructions to select the HF modem by turning the VHF Parameter OFF, then set
the radio baud rate HBAUD to 300.
If you are using a Computer Terminal or a non-Timewave terminal program, the fol-
lowing will setup the HF mode of the PK-232:
Type <CONTROL-C>. (Type C while pressing the <Ctrl> key down.) Your monitor
should respond with the command prompt:
cmd:
Then enter VHF OFF <Enter>
Your monitor should respond with:
Vhf was ON
Vhf now OFF
cmd:
16. We now must change the Radio data-rate (HBAUD) to 300 Baud for HF operation. If
you are using a Computer Terminal or a non-Timewave terminal program the follow-
ing will select a PK-232 HBAUD of 300:
Enter HB 300 <Enter>
Your monitor should respond with:
HBaud was 1200
HBaud now 300
cmd:
17. If you are using an Timewave program type HELLO SELF <Enter>. Your monitor
should soon echo the message you've just typed.
If you are using a Computer Terminal or a non-Timewave terminal program, you
must first type CONV or K followed by a <Enter>. Now you may type a few charac-
ters. Your monitor should soon echo the characters you've just typed.
18. If you are using an Timewave program, follow the instructions to DISCONNECT from
a Packet station.
If you are using a Computer Terminal or a non-Timewave terminal program the fol-
lowing will cause the PK-232 to DISCONNECT:
Enter <CONTROL-C>
Your monitor should respond with the command prompt:
cmd:
Enter D <Enter>
Your monitor should respond with:
cmd:*** DISCONNECTED: AAA
AAA*>AAA (UA)
To Next Page
Loading...