19
FM Mode
Select FM Mode
1. Press MODE button repeatedly to select FM mode.
2. For initial use, it will start at the beginning of the FM frequency range (87.50MHz). Otherwise, the
last listened FM station will be selected.
3. To manually change the FM frequency, make sure no other order/system setting is going on,
press or button to change the frequency by 0.05MHz.
4. To automatically scan, while FM frequency shows up, press or button and then press the
SCAN button, the frequency will move forwards or backwards until it reaches the next available
station.
Scan setting
By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio (hiss)
from weak stations.
1. To change the scan settings to stop only at stations with good signal strength, press MENU
button, press or button to select 'Scan setting', and then press OK button to confirm.
2. Press or button to select 'Strong stations only', and then press OK button to confirm.
Audio Setting
By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a poor
signal-to-noise ratio (hiss).
1. To play weak stations in mono, press MENU button, press or button to select ‘Audio
setting’, and then press OK button to confirm.
2. Press or button to select ‘Forced mono’, and then press OK button to confirm.
To Next Page
Loading...
