Before starting a software upgrade, ensure that your radio is plugged into a stable mains power
connection. Disconnecting power during a software update may permanently damage the unit.
1. Press MENU button > Main menu > System settings > Software update, press OK button to
confirm.
2. Press or button to select 'Auto-check setting', your receiver will check periodically for new
version software.
3. Press or button to select 'Check now', your radio will go to check any new version software
available and enable you to upgrade the detected new version software.
Setup Wizard
When this unit is started for the first time, it runs through a setup wizard to configure settings for
date/time and network. Once this has been finished, the system is ready to use in most modes.
1. Press MENU button > Main menu > System settings > Setup wizard, press OK button to
confirm.
2. Press or button to select 'YES', and then press OK button to confirm.
View System Info
This information may be requested when dealing with technical support issues.
1. Press MENU button > Main menu > System settings > Info, press OK button to confirm.
2. Press or button to view 'SW version', 'Radio ID' and 'Friendly Name'.
Set Backlight
1. Press MENU button > Main menu > System settings > Backlight, press OK button to confirm.
2. Press or button to select ‘Power-on Level' or 'Standby Level', then press OK button to
confirm.
3. Press or button to select backlight level, and then press OK button to confirm the setting.
Power-on Level
High
Low
Off
Standby Level
High
Low
Off
To Next Page
Loading...
