8
Getting Started
Carefully remove your radio from the box. You may wish to store the packaging for future use.
Positioning your Radio Receiver
Place your radio receiver on a flat / stable surface that is not subject to vibrations.
Avoid the following locations:
Where the receiver will be exposed to direct sunlight.
Where the receiver will be close to heat radiating sources.
Where the humidity is high and ventilation is poor.
Where it is dusty.
Where it is damp or there is a possibility of water dripping or splashing onto unit.
Assembling and adjusting the Antenna
Connect the provided antenna to Antenna socket on the back of receiver firstly. Then unwind the
antenna to ensure you receive the best reception possible in both DAB and FM radio modes. It may
be necessary to alter the position of the receiver and /or antenna to achieve the best signal.
Using Headphones
You will require headphones fitted with a 3.5 mm diameter stereo plug. The Audio Out socket is
located on the back of this unit. Headphones are not supplied with this receiver.
Using RCA cable
Connect the 3.5 mm plug at the end of your RCA cable to the Audio Out socket is located on the back
of this unit. Then insert the Red and Black plugs at the other end of the RCA cable to your audio
device.
Turning the Unit On/Off
Connect the plug at the end of power adapter cable to the DC in jack on the back of the unit. Then
insert the power adapter into the mains socket. Press the button to turn on the unit, press the
button again to switch the unit to standby mode. To switch the unit off completely, unplug the power
adapter from the mains socket.
To Next Page
Loading...
