English
11
7. Thread the Quick Flush lid onto the material
container.
10. Depending on the thickness of the material,
some residue may remain on the sprayer
parts.
Remove any remaining residue with the
cleaning brush and the appropriate cleaning
solution.
8. Thread a garden hose into the Quick Flush
lid, and place entire container and cap into an
empty bucket.
IMPORTANT: An empty bucket is needed
because water will flow from the side port (a) of
the Quick Flush lid when the hose is turned on.
11. IMPORTANT: Make sure to completely
remove all material from the inside of the
piston chamber by scrubbing with the
brush.
9. SLOWLY turn on the garden hose. Let the water run for
approximately 30 seconds.
Turn the water off, remove the garden hose and Quick
Flush lid from the material container, and properly
dispose of the cleaning solution. Be careful not to lose
any of the parts that are still in the material container!
12. IMPORTANT: Make sure to keep the vent hole (a) on
the pump housing clean and unblocked or a vacuum
can build up in the container and cause damage to
the sprayer. A toothpick or straightened paper clip
can be used to clean it.
Move on to Reassembly / Maintenance, page 14.
7
10
To Next Page
Loading...
Need help?
General
