English
17
Problem F: Runs and sags in paint
Cause Solution
1.
Arm movement too slow, holding spray gun too close or work
surface, or applying too much paint at one time
See section on spraying (page 8)
Problem G: Material drips from spray tip guard
Cause Solution
1.
Guard is for safety and cannot be removed. Some dripping is
unavoidable with some paints
Use a small brush on drips that fall on surface being sprayed. Use a drop cloth
Problem H: Motor overheats.
Cause Solution
1. Seized piston Clean piston
2. Operating continuously Release trigger at the end of a pass, allow to cool.
Problem I: Material leaking from between spray tip and locking nut.
Cause Solution
1. Spray tip is loose Tighten securely
2. Atomizer valve not positioned properly Unplug the sprayer, remove the spray tip and reposition the atomizer valve
3. Worn atomizer valve Replace
4. Eroded pump housing Replace the pump housing
Troubleshooting
Have you tried the recommendations above and are still having problems? In the United States,
to speak to a customer service representative, call our Customer Service at 1-866-848-2698
Monday through Friday between 8:00 AM and 4:30 PM Central time.
Questions?
Call Titan Technical Service at:
1-866-848-2698
Register your product online at:
www.titantool.com
Proper registration will serve as proof of
purchase in the event your original receipt
becomes misplaced or lost.
This sprayer contains no serviceable parts, besides
the atomizer valves, piston and spring, and spray tip
assemblies. Store indoors.