DIGITAL ELECTRONIC SPEEDOMETER (EN)
The digital electronic speedometer (EN) (1) consists of a large back-lit
display and a series of indicators.
The high beam indicator (2) is at top left, the neutral light (not used) (3)
is at centre left, the ADJUST button (4) is at bottom left.
The turn signal indicator (5) is at top right, the low beam indicator (6) is
at centre right, and the SELECT button (7) is at bottom right.
The display shows the digital speed indicator (speedometer) (8), the trip
odometer (9) or total odometer (ODO).
To switch from TRIP to ODO, briefly press the ADJUST button once. Do
the same to switch from ODO to TRIP.
The unit of measurement of the speedometer and trip and total odometer
is Km/h, but it can be set to Mph as follows: press ADJUST and SELECT
simultaneously for 3 seconds. The current unit of measurement will flash
on the display. Press ADJUST to switch from Km/h to MPH or vice-versa.
Briefly press SELECT 7 times to end the modification and return to the
normal screen.
The trip odometer can be reset by holding the ADJUST button down for
5 seconds.
The total odometer resets automatically when it reaches 99999 Km or
miles.
DIGITAL ELECTRONIC SPEEDOMETER (SMR/SMM)
The digital electronic speedometer (SMR/SMM) (1) consists of a large
back-lit display and a series of indicators.
At the top there is the LH turn signal indicator (2), the low beam indicator
(3), the high beam indicator (4), and the RH turn signal indicator (5).
The display shows the digital speed indicator (speedometer) (6), the trip
odometer (7) and total odometer (8).
There are two buttons at the bottom, “SET” (9) and “MODE” (10).
The unit of measurement of the speedometer is Kmh but it can be set to
Mph as follows: hold down the SET button and simultaneously press the
MODE button once. Do the same to return to Kmh.
The trip odometer can be reset by holding down the SET button for 4
seconds.
The total odometer resets automatically when it reaches 99999 Km or
miles.
2
3
1
8
9
5
6
4 7
To Next Page
Loading...
Need help?
General
