When the device is set to rover station, base station or static mode, the device
will automatically configure the corresponding channel for data storage by default.
1. Rover (CH01)
When the device is set as a rover station, the device will automatically configure
CH01 to store and locate the original data by default. If ppk is enabled, CH05 will
also be automatically configured by default to store post positioning data, as shown in
the following figure.
2. Base (CH02)
When the device is set as the reference station, the device will automatically
configure CH02 to store and locate the original data by default. If ppk is enabled,
CH05 will also be automatically configured by default to store location post-
processing data, as shown in the following figure.
To Next Page
Loading...
