TomTom RIDER 2nd Edition User Manual

13
•
•
•
•
•
•
To use this mount, follow these steps:
1. Carefully remove the bolts that hold the grip in place. Do not remove the
grip from the handlebars.
2. Place the Handlebar Adaptor over the bolt holes.
3. Use the extra-long bolts provided to attach the Handlebar Adaptor and the
grip to the handlebars. Use an Allen key (not provided) to tighten the bolts.
4. Attach the Handlebar Mount to the Handlebar Adapter. Follow steps 2 - 4 in
the section Handlebar Mount above.
You can now place your TomTom RIDER in the Holder. See this section:
Placing your TomTom RIDER in the Holder on page 15.
Mirror Mount
The Mirror Mount is held in place by the wing mirror. If your motorcycle or
scooter has no mirrors but has the bolt holes for a wing mirror, you can still
use the Mirror Mount.
To use this mount, follow these steps:
1. Unscrew one of the wing mirrors on your motorcycle.
2. Place first the rubber washer, then the Mirror Mount and finally the metal
washer over the bolt hole, as shown in the diagram.

TomTom RIDER 2nd Edition Specifications

General

Marine (chartplotters, sounders)	No
Map view options	2D/3D
Form factor	Fixed
Channels quantity	20 channels
Display diagonal	3.5 \
Display resolution	320 x 240 pixels
Internal memory	32 MB
Power requirements	12V
Processor frequency	380 MHz
USB 2.0 ports quantity	1
Battery life (max)	5 h
Operating temperature (T-T)	-10 - 55 °C

Weight and Dimensions

Depth	96.2 mm
Width	113.2 mm
Height	52.9 mm
Weight	310 g