6
USAGE AND MAINTENANCE
USAGE
The CV-5000 Compu-Vision is an electric instrument. Use this instrument according to the
instruction manual.
USER MAINTENANCE
To ensure the safety and performance of this instrument, all maintenance work, unless
specified in this manual, shall be conducted by trained service engineers.
The following maintenance task may be done by the user.
For details, see the relevant part of this manual.
Replacing the face shield/forehead rest
The forehead rest and face shield on this instrument may be replaced by the user. Refer to
"INSTALLING THE FACE SHIELD AND FOREHEAD REST" on page 15 for handling them.
Replacing the fuse
The fuses on this instrument may be replaced by the user. For details, refer to "REPLAC-
ING THE FUSE" on page 44.
Inspecting the instrument
It is recommended to inspect the mounting section for the CV-5000 and the system table
about its looseness periodically. Refer to "INSPECTING THE OPTOMETRY UNIT
MOUNTING SECTION" on page 46 for details.
ESCAPE CLAUSE
• TOPCON shall not take any responsibility for damage due to fire, earthquakes, actions
by third persons and other accidents, or damage due to negligence and misuse by the
user and any use under unusual conditions.
• TOPCON shall not take any responsibility for damage derived from inability to properly
use this instrument, such as loss of business profit and suspension of business.
• TOPCON shall not take any responsibility for damage caused from using this instru-
ment in a manner other than that described in this instruction manual.
• Diagnoses made shall be the responsibility of pertaining doctors and TOPCON shall
not take any responsibility for the results of such diagnoses.
To Next Page
Loading...
Need help?
General
