Chapter 2 Standard Features 17
The green and blue LEDs are in the same location. They
can not be shown simultaneously. These LEDs can be
programmed by a developer. Sample code is available
upon request
Light Sensor
All units have an ambient light sensor located on the front
of the FC-5000. The light sensor dynamically adjusts the
backlight on the display.
You can disable this process and manually control the
display brightness if you prefer. Go to the Start menu
and select Settings > System > Display. Turn off Change
brightness automatically when lighting changes and tap
Apply. To manually adjust the display backlight, tap on
the battery icon at the bottom of the desktop screen. The
display backlight brightness can easily be toggled up or
down in 25% increments from 0% to 100% by tapping the
percent tile (see the sun icon).
SD Cards
The FC-5000 has a slot for a micro SD card located in the
battery compartment. The card slot and exible card
holder are designed to hold the card securely in place so it
will not come out or disconnect if the tablet is dropped. To
insert or remove a card, follow these steps:
1. Power off the tablet.
2. Remove the battery door as outlined in chapter 1.
CAUTION: The FC-5000 is not sealed against water and
dust when the battery pack and battery door are not
installed properly.
CAUTION: Always power off the tablet before removing
the battery. Failure to do so may cause loss of data or
damage to the tablet. EXCEPTION: If your tablet has an
internal battery, this caution does not apply. You can
safely remove the removable battery while the unit is
running.
3. Remove the battery pack by pulling up on the black tab
on the battery pack.
!
!