37
Operation at the alignment target side
1 Press the Auto/manual alignment key. The green Auto/manual alignment key LED will
light.
2 Press either the X1 or X2 key to set scanning for the side of the laser that has the target.
The laser starts scanning and the selected key's LED will flash.
3 Center the alignment target on the far control point, passing it slowly through the beam.
The beam will begin to move, and will align to the center of the target automatically.
When the beam reaches the center of the target, the scanning width will narrow, and will
automatically focus.
X1
X2
Auto/manual
alignment pad
Alignment
target
Control point
X1
X2
Green LED
To Next Page
Loading...
