Topens TC148 - User Manual

C030640
User Manual of Wired Push Button
(Item No. TC148)
Installation of the Waterproof Push Button
Step 1: Separate the back cover from the push button and drill four holes in the wall corresponding to the 4
installing holes on the back cover of the push button.
Step 2: Insert plastic anchors into the 4 holes drilled in the wall and then install the back cover to the wall with the
screws. (The plastic anchors and the installing screws are not included in the kit).
Step 3: Wire the push button to your opener and then route the wire through the bottom of the push button. Finally
fix the front cover of the push button to the back cover with the screws included in the kit.
Connection of the push button
You can connect the COM and L1 terminals of the push button to the terminals for push button of the gate opener.
No matter the polarity.
NOTE: Please read this manual carefully before installation.

Summary

Installation of the Waterproof Push Button

Step 1: Separate the back cover from the push button

Separate back cover, drill four wall holes corresponding to push button's installing holes.

Step 2: Insert plastic anchors into the 4 holes drilled in the wall

Insert plastic anchors into wall holes, then install back cover with screws (anchors/screws not included).

Step 3: Wire the push button to your opener

Wire push button to opener, route wire through bottom, fix front cover with included screws.

Connection of the push button

Topens TC148 Specifications

General

Brand	Topens
Model	TC148
Category	Gate Opener
Language	English