54 Recording and Playback
NOTE
Edited files cannot be fast-forwarded and rewinded. The
F4 and
F3 buttons are still active for this feature.
7.5 Copying a recording
You can record the file in whole or in part during a playback
by performing the following steps:
1. Start playback of a recording you want.
2. Move to a scene from which you want to start copying by
holding down the
b
or
d
button.
3. Press the button, then it will be copied in a new file
which is named after the original recording with a suffix
of ‘COPY’ and a number.
4. To stop copying, press the button.
7.6 Formatting the hard disk
If a new hard drive is installed, it must be formatted because
you can neither record nor use time-shift with an unformatted
hard disk.
You can delete permanently all contents stored in a hard drive
by formatting it. Select the Installation > System Recovery >
Format Hard Disk menu, and then select the hard drive you
want to format. To format the built-in hard drive, select the
option to Internal; otherwise to format the external hard drive
which is connected to the digital receiver, select the option to
External. With pressing the
OK button, you get asked for con-
firmation. Formatting will start with the choice of Yes.
NOTE
The hard drive on the digital receiver will be formatted in
the JFS file system.
To Next Page
Loading...
