Toro 04383 - Optional Oil Cooler; Installing the Cutting Units (for Cutting Unit Models 04610, 04611 and 04616 Only)

6
AdjustingtheCarrierFrame
Rollers
NoPartsRequired
Procedure
1.Positionthemachineonalevelsurfaceandlowerthe
cuttingunitcarrierframestotheoor.
2.Verifythatthereis1/2in.(13mm)clearancebetween
thecarrierframerollersandtheoor.
3.Ifanadjustmentisrequired,loosenthejamnutonthe
carrierframestopscrew(
Figure10)androtatethe
screwupordowntoraiseorlowerthecarrierframe.
Tightenthejamnutafteradjustmentisattained.
Figure10
1.Carrierframeroller2.Carrierframestopscrew
7
OptionalOilCooler
NoPartsRequired
Procedure
Ifyouareoperatingthemachineinhotclimates,where
ambienttemperaturesrangefrom70degreesF(20degreesC)
to120degreesF(49degreesC),orusingitforheavy-dutyuse
(mowingotherthangreens,suchasfairwaysorverticutting),
installaHydraulicOilCoolerKit,PartNo.104–7701,tothe
machine.
8
InstallingtheCuttingUnits
(ForCuttingUnitModels
04610,04611and04616Only)
Partsneededforthisprocedure:
1
OffsetLiftHook
2Bolts,M10–1.5
1
Gaugebar
1
Bolt(#10x5/8inch)
1
Jamnut(#10)
3
Cuttingunit
6Washer
6Ballstud
3
GrassBasket
Procedure
Note:Whensharpening,settingtheheight-of-cutor
performingothermaintenanceproceduresonthecutting
units,storethecuttingunitreelmotorsinthesupporttubes
topreventdamagetothehoses.
Important:Donotraisethesuspensiontothetransport
positionwhenthereelmotorsareintheholdersinthe
machineframe.Damagetothemotorsorhosescould
result
Important:Wheneverthecuttingunithastobetipped
toexposebedknife/reel,propuprearofcuttingunitto
makesurenutsonbackendofbedbaradjustingscrews
arenotrestingonworksurface(Figure11).
17