Toro 04383 - Page 18

Figure11
1.Prop(notprovided)2.Bedknifeadjustingscrew
nut(2)
1.Removethecuttingunitsfromthecartons.Assemble
andadjustthemaslistedinthecuttingunitOperator's
Manual.Usethegaugebarfromtheloosepartskitto
adjusttheheightofcut.
2.Installtheoffsetlifthook(Figure12)tothetopofthe
cuttingunitwith(2)M10–1.5bolts.Torquethebolts
to25–30ft–lbs.(34–40N⋅m).Theoffsetlifthook
shouldbepositionedwithhookforward.
Figure12
1.Offsetlifthook
3.Allcuttingunitsareshippedwiththecounterweight
mountedtotheleftendandthemotormountanddrive
couplermountedtotherightendofthecuttingunit.
Tomountthecuttingunitintherightfrontposition,
proceedasfollows:
A.Removethe2boltssecuringthecounterweight
totheleftendofthecuttingunit.Removethe
counterweight(Figure13).
Figure13
1.Counterweight
B.Onrightendofcuttingunit,removeplasticplug
frombearinghousing(Figure14).
Note:Retaintheprotectivecoversforthecutting
units.Installthemwheneverthereeldrivemotors
areremovedtoprotectthecuttingunitbearings
fromcontamination.
C.Removethe2allenheadscrewssecuringthe
motormounttotherightendofthecuttingunit.
Removethemotormount(Figure14).
Figure14
1.Motormount
3.Allenheadscrew(2)
2.Plasticplug
D.Removethesnapringsecuringthedrivecoupler
inthereeltube(Figure15).Removethedrive
coupler.
18