Toro 04384 - Page 226

Greensmaster 3250--D
DPA Cutting Units
Page 7 -- 32
Rear Roller Brush (Optional)
1. Cover
2. Drive belt
3. Drive pulley
4. Pulley driver
5. Cap screw
6. Idler pulley assembly
7. Cover plate
8. Flange nut (5 used)
9. Drive plate
10. Driven pulley
11. Square key
12. Threadlock screw (4 used)
13. Roller bearing assembly (2 used)
14. Grease fitting (2 used)
15. LH brush support
16. Flange head screw (4 used)
17. Brush assembly
18. O--ring
19. Flat washer
20. Bearing spacer
21. Spacer
22. Cap screw
23. Bearing spacer
24. Hex nut (2 used)
25. Weight
26. Cap screw (2 used)
Figure 35
FRONT
RIGHT
FRONT
RIGHT
70 to 80 in--lb
(8 to 9 N--m)
Antiseize
Lubricant
100 ft--lb
(136 N--m)
130 to 140 in--lb
(15to16N--m)
26
2
3
6
8
9
10
11
13
1
5
7
12
14
15
16
17
18
19
20
4
21
22
23
8
12
12
24
25
NOTE: Drive components for the rear roller brush are
located on the opposite side of the cutting unit from the
hydraulic cutting reel motor. Figure 35 shows compo-
nents used when the brush drive is on the right side of
the cutting unit.
NOTE: The Installation Instructions for the rear roller
brush kit has detailed information regarding assembly
and adjustment. Use those Instructions along with this
Service Manual when servicing the rear roller brush.