22
MAINTENANCE SCHEDULE
Minimum Recommended Maintenance Intervals
Inspect Air Filter, Dust Cup and Baffle
Lubricate All Grease Fittings
Check Cutting Unit Gear Box Oil Level
Change Engine Oil and Filter
Check Battery Level/Cable Connections
Inspect Cooling System Hoses
Inspect PTO and Cutting Unit Belts
Check Electric Deck Clutches Adjustment
Check Electric PTO Clutch Adjustment
Torque Wheel Lug Nuts
Service Air Cleaner
Change Fuel Filter
Check Front Transaxle Oil Level
Check Rear Axle Oil Level
Inspect Fuel Lines and Connections
Check Engine RPM (idle and full throttle)
Inspect Engine Fan Belt
Inspect Engine Timing Belt (see note below)
Drain and Clean Fuel Tank
Change Hydraulic Oil
Change Hydraulic Oil Filter
Change Front Transaxle Oil
Change Rear Axle Oil
Change Bidirectional Clutch Fluid
Check Rear Wheel Toe-in
Initial break in at 10 hours
Initial break in at 50 hours
If indicator shows red
Replace Moving Hydraulic Hoses
Replace Safety Switches
Cooling System Flush/Replace Fluid
Replace PTO Belts/Cutter Deck Belts
Maintenance Procedure
Every
50hrs
Every
100hrs
Every
200hrs
Every
800hrs
Maintenance Interval & Service
Annual Recommendations:
Items listed are recommended every 1500
hours or 2 years, whichever occurs first.
Every
400hrs
NOTE: Replace Timing Belt if worn, cracked or oil soaked. A new Timing Belt should be installed
any time the Belt is removed or loosened.
To Next Page
Loading...
