Toro 30473 - Adjusting the Maximum Ground Speed; Adjusting the Tracking

WARNING
Theelectricalsystemdoesnotperformproper
safetyshutoffwiththejumperwireinstalled.
•Removethejumperwirefromthewire
harnessconnectorandplugtheconnector
intotheseatswitchwhenyoucomplete
adjustment.
•Neveroperatethemachinewiththejumper
installedandtheseatswitchbypassed.
13.Lowertheseatintoposition.
14.Removethejackstands.
AdjustingtheMaximum
GroundSpeed
1.DisengagethePTO,movethemotion-controlleversto
theNEUTRAL-LOCKposition,andsettheparkingbrake.
2.MovethethrottlelevertotheSLOWposition,stopthe
engine,removethekey,andwaitforallmovingpartsto
stopbeforeleavingtheoperatingposition.
3.Unlatchtheseatandpivotitforward.
Note:Ifyouneedadditionalaccessundertheseat,
youcanremovethesidepanels.
4.Loosenthejamnutonthestopboltforacontrollever
(Figure43).
Figure43
1.Stopbolt
3.Jamnut
2.Controllever4.1.5mm(0.060inch)
5.Threadthestopboltallthewayin(awayfromthe
controllever).
6.Pushthecontrolleverallthewayforwarduntilitstops
andholditthere.
7.Threadthestopboltout(towardthecontrollever)
untilthereisagapof1.5mm(0.060inch)betweenthe
headofthestopboltandthecontrollever.
Note:Ifyouwanttoreducethemaximummachine
speed,backeachstopboltoutanequalamounttoward
thecontrolleveruntilyoureachthedesiredmaximum
speed.Youmayneedtotestyouradjustmentseveral
times.
8.Tightenthejamnuttosecurethestopboltinplace.
9.Repeatsteps4through8fortheothercontrollever.
10.Lowertheseat.
AdjustingtheTracking
1.DisengagethePTO,movethemotion-controlleversto
theNEUTRAL-LOCKposition,andsettheparkingbrake.
2.MovethethrottlelevertotheSLOWposition,stopthe
engine,removethekey,andwaitforallmovingpartsto
stopbeforeleavingtheoperatingposition.
3.Loosentheboltssecuringthecontrollevers(Figure44)
Figure44
1.Controllever
3.Bolts
2.Control-leverpost
4.Havesomeonepushthecontrol-leverposts(not
thecontrollevers)allthewayforwardintothe
maximum-speedpositionandholdthemthere.
5.Adjustthecontrolleverssothattheylineupandtighten
thebolts,securingtheleverstotheposts(Figure45).
33