Problem
Possible Cause Corrective Action
1. The throttle is not in the F AST position
when throwing snow .
1. Move the throttle to the F AST position.
2. The machine is moving too fast to clear
the snow .
2. Shift the machine into a lower gear .
3. Y ou are trying to remove too much
snow per swath.
3. Reduce the amount of snow removed
per swath.
4. Y ou are trying to remove extremely
heavy or wet snow .
4. Do not overload the machine with
extremely heavy or wet snow .
5. The discharge chute is plugged. 5. Unclog the discharge chute.
6. The auger/impeller drive belt is loose
or is of f the pulley .
6. Install and/or adjust the auger/impeller
drive belt; refer to www .T oro.com
for servicing information or take the
machine to an Authorized Service
Dealer .
The engine runs, but the machine
discharges snow poorly or not at all.
7. The auger/impeller drive belt is worn
or broken.
7. Replace the auger/impeller drive belt;
refer to www .T oro.com for servicing
information or take the machine to an
Authorized Service Dealer .
The discharge chute either does not lock
into place or does not move.
1. The discharge-chute latch cable is not
properly adjusted.
1. Adjust the discharge-chute latch cable.
1. The skids and/or scraper are not
properly adjusted.
1. Adjust the skids and/or the scraper .
The machine does not properly clear the
snow of f the surface.
2. The pressure in the tires is not equal.
2. Check and adjust the pressure in 1 or
both tires.
28
To Next Page
Loading...
