34
Changing the Engine Oil Filter
1. Drain the oil from the engine; refer to Changing Oil,
page 33, steps 1 through 7.
2. Remove the old filter (Fig. 36).
1
2
Figure 36
1. Oil filter 2. Filter adapter
3. Wipe the filter adapter gasket surface (Fig. 36).
4. Apply a thin coat of new oil to the rubber gasket on the
replacement filter (Fig. 36).
5. Install the replacement oil filter to the filter adapter.
Turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 1/2 turn (Fig. 36).
6. Fill the crankcase with the correct type of new oil; refer
to Changing Oil, page 33, steps 8 through 10.
7. Dispose of the used oil filter at a certified recycling
center.
Greasing the Sprayer
Lubricate all bearings and bushings after every 100 hours
or once a year, whichever occurs first.
Grease Type: No. 2 General Purpose Lithium Base Grease
1. Wipe the grease fitting clean so that foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off excess grease.
The grease fitting locations are in the positions illustrated
in Figures 37 through 43.
Figure 37
Figure 38
Four on each side
Figure 39
Three on each side
To Next Page
Loading...
