Toro 41188 User Manual (English)

Other manuals for Toro 41188

Questions and Answers:

J
Jorge FoxAug 21, 2025
Why is my Toro Paint Sprayer starter not cranking?
- J
  James ManningAug 21, 2025
  If the Toro Paint Sprayer's starter doesn't crank, it could be due to several reasons. First, ensure the range selector is in NEUTRAL and the brake pedal is pressed. Second, check for corroded or loose electrical connections. Third, inspect and replace any blown or loose fuses. Fourth, charge or replace the battery if it's discharged. If these steps don't resolve the issue, the safety-interlock system, starter, starter solenoid, or internal engine components may be broken, requiring assistance from an Authorized Service Dealer.
J
Jose BakerAug 23, 2025
What to do if Toro Paint Sprayer engine cranks but does not start?
- J
  John MathisAug 23, 2025
  If your Toro Paint Sprayer's engine cranks but doesn't start, the fuel tank might be empty; if so, fill it with fresh fuel. Alternatively, the fuel system might contain dirt, water, or stale fuel, in which case you should drain and flush the system before adding fresh fuel. A clogged fuel line could also be the culprit, requiring cleaning or replacement. Ensure the spark plug lead is connected and that the spark plug isn't damaged or dirty; replace the spark plug if necessary. If these steps don't work, the kill relay or ignition may be broken, and you should contact an Authorized Service Dealer.
D
Donald HowardAug 25, 2025
Why does my Toro 41188 Paint Sprayer engine lose power?
- J
  James KingAug 25, 2025
  If your Toro Paint Sprayer engine loses power, start by checking the crankcase-oil level and adjust it to the FULL mark. Also, ensure the air-cleaner element is clean or replace it if dirty. Dirt, water, or stale fuel in the fuel system can also cause this issue, so drain and flush the system, then add fresh fuel. A damaged or dirty spark plug should be replaced. If the vent hole in the fuel tank vent fitting is plugged, replace the fuel cap. For overheating issues or low compression, contact an Authorized Service Dealer.
D
Dylan SmithAug 26, 2025
Why does my Toro 41188 Paint Sprayer start but not stay running?
- S
  Seth ChurchAug 27, 2025
  If your Toro Paint Sprayer engine starts but doesn't keep running, the fuel tank vent may be restricted; try replacing the fuel cap. Also, dirt or water in the fuel system can cause this, so drain and flush the system and add fresh fuel. A clogged fuel filter should be replaced. Check and replace any blown or loose fuses. For issues with the fuel pump, carburetor, or a broken cylinder head gasket, or if there are loose wires or poor connections, contact an Authorized Service Dealer; otherwise, check and tighten the wire connections.
T
Tanya AbbottAug 28, 2025
How to fix Toro Paint Sprayer engine overheating?
- Z
  zlarsonAug 28, 2025
  If your Toro Paint Sprayer engine overheats, first check the crankcase-oil level and adjust it to the FULL mark. Reduce the load and use a lower ground speed if there is excessive loading. Clean the air-intake screens with every use. Also, clean the cooling fins and air passages under the engine blower housing and/or the rotating air-intake screen with every use. For a lean fuel mixture, contact an Authorized Service Dealer.
W
William JonesAug 29, 2025
Why won't my Toro 41188 Paint Sprayer engine idle properly?
- T
  theresa23Aug 29, 2025
  If your Toro Paint Sprayer engine does not idle, the fuel tank vent may be restricted, so replace the fuel cap. Also, dirt, water, or stale fuel in the fuel system can cause this, so drain and flush the system and add fresh fuel. Replace any damaged or broken spark plugs. Clean or replace the air-cleaner element if it's dirty. For plugged carburetor idle passages, an incorrectly set idle speed adjusting screw, a broken fuel pump, or low compression, contact an Authorized Service Dealer.
C
Catherine MartinezAug 30, 2025
Why is my Toro 41188 Paint Sprayer engine knocking?
- S
  Stephanie HancockAug 31, 2025
  If the Toro Paint Sprayer engine runs but knocks or misses, it could be due to dirt, water, or stale fuel in the fuel system; drain and flush the system, then add fresh fuel. Ensure the spark plug lead is securely connected and replace any broken spark plugs. Check and tighten any loose wires or poor connections. If the engine is overheating, refer to the section on 'The engine overheats'.
J
Joanne GlassSep 1, 2025
What to do if a section of my Toro 41188 does not spray?
- T
  torreskatherineSep 1, 2025
  If a section of your Toro Paint Sprayer does not spray, first, manually turn off the valve, disconnect the electrical connector, clean all leads, and then reconnect it, if the electrical connection on the section valve is dirty or disconnected. Check and replace the fuses as necessary if there is a blown fuse. Repair or replace the hose if there is a pinched hose. Adjust the section bypass if it is improperly adjusted. For damaged section valve or electrical system, contact your Authorized Service Dealer.
E
Elizabeth GallagherSep 3, 2025
Why is there a pressure drop when I turn on a section of my Toro 41188?
- S
  Sean MillerSep 3, 2025
  If a pressure drop occurs when you turn on a section of your Toro Paint Sprayer, adjust the section bypass if it is improperly adjusted. Remove the inlet and outlet connections to the section valve and remove any obstructions if there is an obstruction in the section valve body. Remove and inspect all nozzles if a nozzle filter is damaged or clogged.
T
Teresa PerezSep 4, 2025
Why does my Toro 41188 Paint Sprayer not operate in either direction?
- R
  Robert MendozaSep 4, 2025
  If the Toro Paint Sprayer does not operate in either direction, ensure the range selector is not in the NEUTRAL position by pressing the brake and shifting the range selector into a gear. Also, make sure the parking brake is released and check the linkage. For a broken transmission, control linkage needing adjustment or replacement, or a damaged driveshaft or wheel-hub key, contact an Authorized Service Dealer.