Toro 74267 - Page 69

g001041
Figure94
1.Measureherefromblade
tohardsurface
2.MeasureatAandB
2.MeasuretherightbladeattheAlocation,from
alevelsurfacetothecuttingedgeoftheblade
tip(Figure94).
3.Recordthismeasurement.
4.MeasuretherightbladeattheBlocation,from
alevelsurfacetothecuttingedgeoftheblade
tip(Figure94).
5.Recordthismeasurement.
6.Themowerbladeshouldbe6to10mm(1/4to
3/8inch)loweratpositionAthanatpositionB
(Figure94).Ifitisnotcorrect,proceedtothe
followingsteps.
Note:Bothofthefrontswivelsneedtobe
adjustedthesameamounttomaintainequal
chaintension.
7.Loosenthefrontswiveljamnuts,atthefrontof
therightandleftswivels,approximately13mm
(1/2inch)(Figure93).
8.Adjusttheliftnutsonboththeleftandtheright
sideofthemachinetoachieve6to10mm(1/4
to3/8inch)lowerinfrontatAthanintherear
atB(Figure93).
9.Tightenbothswiveljamnutsagainstthefront
swiveltolocktheheight.
10.Checktomakesurethatthereisequaltension
onthechainsandadjustagainifneeded.
AdjustingtheCompressionSpring
1.Raisethemowerliftlevertothetransport
position.
2.Checkthedistancebetweenthe2large
washers,itneedstobe28.2cm(11-1/8inches)
for52inchmowerdecks,26.7cm(10-1/2
inches)for60inchmowerdecks,or29.2cm
(11-1/2inches)for72inchmowerdecks(Figure
95).
g002479
Figure95
1.28.2cm(11-1/8inches)
betweenthelargewashers
for52inchmowerdecks
6.Liftnut
2.Frontnut7.Front-supportarm
3.Spring-jamnut
8.Largewasher
4.Frontswivel
9.26.7cm(10-1/2inches)
betweenthelargewashers
for60inchmowerdecks
5.Swiveljamnut10.29.2cm(11-1/2inches)
betweenthelargewashers
for72inchmowerdecks
3.Adjustthisdistance,bylooseningthespring-jam
nutandturningthenutinfrontofeachspring
(Figure95).
Note:Turningthenutclockwiseshortensthe
spring;counter-clockwiselengthensthespring.
4.Lockthenutintopositionbytighteningthe
spring-jamnut(Figure95).
69