Toro 74766 - Page 10

decal132-0869
132-0869
This machine complies with the industry standard stability test in the static lateral and longitudinal tests with the maximum
recommended slope indicated on the decal. Review the instructions for operating the machine on slopes in the Operator's
Manual and the conditions in which the machine is being operated to determine whether the machine can be operated in
the conditions on that day and at that site. Changes in the terrain can result in a change in slope operation for the machine.
If possible, keep the cutting units lowered to the ground while operating the machine on slopes. Raising the cutting units
while operating on slopes can cause the machine to become unstable.
1. Warning—read the
Operator's Manual.
3. Cutting hazard of hand,
mower blade; pinching
hazard of hand, belt—keep
hands and feet away from
moving parts; keep all
guards and shields in place.
5. Ramp tipping
hazard—when loading
onto a trailer, do not use
dual ramps; only use a
single ramp wide enough
for the machine and that
has an incline less than
15 degrees; back up the
ramp (in reverse) and drive
forward off the ramp.
7. Tipping hazard on
slopes—do not use on
slopes near open water; do
not use on slopes greater
than 15 degrees.
2. Warning—before servicing,
engage the parking brake,
remove the key and the
spark plug connection.
4. Thrown object
hazard—keep bystanders
away from the machine;
remove debris from the
area before mowing; keep
the deector shield down.
6. Bodily harm hazard—no
riders; look behind you
when mowing in reverse.
10