Drive System
Maintenance
Checking the Tire Pressure
Service Interval: Every 25 hours—Check tire pressure.
Maintain the air pressure in the front and rear tires as
specied. Uneven tire pressure can cause uneven cut. Check
the pressure at the valve stem (Figure 47). Check the tires
when they are cold to get the most accurate pressure reading.
Refer to the maximum pressure suggested by the tire
manufacturer on the sidewall of the caster wheel tires.
Inate the rear drive wheel tires to 90 kPa (13 psi).
g000554
Figure 47
1. Valve stem
Releasing the Electric
Brake
You can manually release the electric brake by rotating the
link arms forward. Once the electric brake is energized, the
brake resets.
1. Turn the ignition key to the OFF position or disconnect
the battery.
2. Locate the shaft on the electric brake where the brake
link arms are connected (Figure 48).
3. Rotate the shaft forward to release the brake.
g027911
Figure 48
1. Brake-link arm on the electric brake control module
2. Left, rear tire
38
To Next Page
Loading...
Need help?
General
