Toro 74766 User Manual (English)

Questions and Answers:

F
Francisco McknightAug 13, 2025
What to do if my Toro Lawn Mower engine does not start, starts hard, or fails to keep running?
- S
  Sheila BryantAug 13, 2025
  If your Toro Lawn Mower engine is not starting, starts with difficulty, or won't stay running, consider these possible causes and solutions: * The fuel tank may be empty, in which case you should fill the fuel tank. * The air cleaner may be dirty, so you should clean or replace the air-cleaner element. * The spark plug wire(s) may be loose or disconnected; install the wire(s) on the spark plug. * The spark plug(s) may be pitted, fouled, or have an incorrect gap. Install a new, correctly gapped spark plug(s). * There may be dirt in the fuel filter; replace the fuel filter. * There may be incorrect fuel in the fuel tank; drain the tank and replace the fuel with the proper type. * The oil level in the crankcase may be low; add oil to the crankcase.
J
jriosAug 16, 2025
What to do if my Toro Lawn Mower starter does not crank?
- E
  edwardsericAug 16, 2025
  If the starter on your Toro Lawn Mower doesn't crank, here are a few things you can check: * The blade-control switch is engaged; move the blade-control switch to Disengaged. * The motion-control levers are not in the PARK position; move the motion-control levers outward to the PARK position. * The battery is dead; charge the battery. * The electrical connections are corroded or loose; check the electrical connections for good contact. * A fuse is blown; replace the fuse.
J
Jessica PayneAug 21, 2025
Why does my Toro Lawn Mower engine overheat?
- C
  cwilsonAug 21, 2025
  Several factors can cause your Toro Lawn Mower engine to overheat: 1. The engine load may be excessive; reduce the ground speed. 2. The oil level in the crankcase may be low; add oil to the crankcase. 3. The cooling fins and air passages under the engine blower housing may be plugged; remove the obstruction from the cooling fins and air passages. 4. The air cleaner may be dirty; clean or replace the air-cleaner element.
M
mmayAug 25, 2025
Why does my Toro 74766 engine lose power?
- M
  matthew97Aug 25, 2025
  Your Toro Lawn Mower engine may be losing power due to several reasons: * The engine load is excessive; reduce the ground speed. * The air cleaner is dirty; clean the air-cleaner element. * The oil level in the crankcase is low; add oil to the crankcase. * The cooling fins and air passages under the engine blower housing are plugged; remove the obstruction from the cooling fins and air passages. * The spark plug(s) is pitted, fouled, or the gap is incorrect; install a new, correctly gapped spark plug(s). * There is dirt in the fuel filter; replace the fuel filter. * There is incorrect fuel in the fuel tank; drain the tank and replace the fuel with the proper type.
J
John PierceAug 28, 2025
Why is the cutting height uneven on my Toro 74766 Lawn Mower?
- D
  Derrick ThompsonAug 28, 2025
  Uneven cutting height on your Toro Lawn Mower can be caused by: * The blade(s) is not sharp; sharpen the blade(s). * A cutting blade(s) is/are bent; install a new cutting blade(s). * The mower is not level; level the mower from side-to-side and front-to-rear. * An anti-scalp wheel is not set correctly; adjust the anti-scalp wheel height. * The underside of the mower is dirty; clean the underside of the mower. * The tire pressure is incorrect; adjust the tire pressure.
T
Terry WoodSep 1, 2025
What causes the blades on my Toro 74766 not to rotate?
- J
  Jenna JohnsonSep 1, 2025
  If the blades on your Toro Lawn Mower aren't rotating, consider the following: * The drive belt may be worn, loose, or broken; install a new drive belt. * The drive belt may be off the pulley; install the drive belt and check the adjusting shafts and belt guides for the correct position. * The mower belt is worn, loose, or broken; install a new mower belt.
T
Tyler GarciaSep 5, 2025
What causes abnormal vibration in my Toro 74766 Lawn Mower?
- J
  James AdkinsSep 5, 2025
  Abnormal vibration in your Toro Lawn Mower can stem from several sources: * The engine-mounting bolts are loose; tighten the engine-mounting bolts. * The engine pulley, idler pulley, or blade pulley is loose; tighten the appropriate pulley. * The cutting blade(s) is/are bent or unbalanced; install a new cutting blade(s). * A blade-mounting bolt is loose; tighten the blade-mounting bolt.
E
Elizabeth SullivanSep 8, 2025
Why doesn't my Toro 74766 Lawn Mower drive?
- F
  ffisherSep 8, 2025
  If your Toro Lawn Mower isn't driving, it could be due to the bypass valves being open; close the tow valves.

Toro 74766 Specifications

General

Model	74766
Start Type	Recoil
Deck Material	Steel
Engine	Briggs & Stratton
Cutting Width	22 inches
Drive Type	Self-Propelled
Drive System	Rear Wheel Drive

Summary

Introduction

Model and Serial Number Plate

Locate and record the machine's model and serial numbers for reference.

Safety

General Safety Guidelines

Essential safety precautions for operating the lawn mower to prevent injury.

Slope Indicator

Safety and Instructional Decals

Product Overview

Controls

Overview of the mower's control panel, ignition, choke, throttle, and blade switch.

Controls Operation

Motion-Control Levers

Instructions for operating the machine's forward, reverse, and turning controls.

Smart Speed™ Control System

Using the speed selector for trim, tow, and mow operations.

Height-of-Cut Lever

How to adjust the mower deck's cutting height.

Attachments and Accessories

Information on available optional equipment for the mower.

Operation

Before Operation Safety

Crucial safety measures before starting the mower.

Recommended Fuel

Guidelines on the type of gasoline suitable for the mower's engine.

Fuel System Maintenance

Using Fuel Stabilizer/Conditioner

How to use fuel stabilizer/conditioner for storage and maintenance.

Filling the Fuel Tank

Step-by-step instructions for safely filling the mower's fuel tank.

Engine Maintenance

Checking Engine-Oil Level

Procedure for checking the engine oil level before operation.

Breaking in a New Machine

Recommended break-in period for new engines and drive systems.

Safety-Interlock System

Safety-Interlock System Operation

Explanation of how the safety-interlock system prevents engine start or operation.

Testing the Safety-Interlock System

Positioning the Seat

Adjusting the Motion-Control Levers

Adjusting Lever Height

How to adjust the height of the motion-control levers for comfort.

Adjusting the Tilt

During Operation Safety

Operating the Mower Blade-Control Switch (PTO)

Engaging the PTO Switch

Procedure for engaging the mower blades using the PTO switch.

Disengaging the PTO Switch

Procedure for disengaging the mower blades using the PTO switch.

Operating the Throttle

Operating the Choke

Operating the Ignition Switch

Starting and Shutting Off the Engine

Starting the Engine

Procedure for starting the mower engine, including safety checks.

Shutting Off the Engine

Procedure for safely shutting down the mower engine.

Driving Forward and Backward

Smart Speed™ Control System Usage

Trim Speed Setting

Information on the Trim speed range and its recommended applications.

Tow Speed Setting

Information on the Tow speed range and its recommended applications.

Mow Speed Setting

Information on the Mow speed range and its recommended applications.

Stopping the Machine

Adjusting the Height of Cut

Adjusting the Anti-Scalp Rollers

Using the Side Discharge

Operating Tips

Mowing Best Practices

Tips for throttle, cutting intervals, direction, speed, and avoiding scalping.

Keeping the Underside of the Mower Clean

Maintaining the Blade(s)

After Operation Safety

Pushing the Machine by Hand

Transporting the Machine

Loading and Securing the Machine

Instructions for loading the mower onto a trailer and securing it.

Maintenance

Recommended Maintenance Schedule

Overview of maintenance tasks and their recommended service intervals.

Pre-Maintenance Procedures

Maintenance and Storage Safety

General safety guidelines and steps before performing maintenance.

Raising the Seat

Lubrication

Greasing the Bearings

Procedure and interval for greasing the mower's lubrication points.

Engine Maintenance

Engine Safety

Safety precautions to take when performing engine maintenance.

Servicing the Air Cleaner

Steps for removing and servicing the air cleaner elements.

Servicing the Engine Oil

Checking the Engine-Oil Level

Changing the Engine Oil and Oil Filter

Servicing the Spark Plug

Removing and Checking the Spark Plug

Steps for removing, checking, and replacing the spark plug.

Installing the Spark Plug

Cleaning the Cooling System

Fuel System Maintenance

Replacing the In-Line Fuel Filter

Procedure for checking and replacing the inline fuel filter.

Electrical System Maintenance

Electrical System Safety

Safety precautions for working with the mower's electrical system.

Servicing the Battery

Guidelines for servicing and removing the mower's battery.

Charging the Battery

Installing the Battery

Servicing the Fuses

Drive System Maintenance

Checking the Tire Pressure

Procedure for checking and maintaining proper tire pressure.

Releasing the Electric Brake

Mower Maintenance

Servicing the Cutting Blades

Comprehensive guide to blade safety, inspection, and servicing procedures.

Blade Removal and Installation

Removing the Blades

Steps for safely removing mower blades.

Installing the Blades

Steps for correctly installing mower blades.

Mower Deck Leveling

Leveling from Side to Side

Procedure to ensure the mower deck is level from side to side.

Adjusting the Front-to-Rear Blade Slope

Removing the Mower Deck

Replacing the Grass Deflector

Installing the Mower

Mower Belt Maintenance

Inspecting and Replacing Mower Belts

Procedure for inspecting belts for wear and replacing damaged belts.

Cleaning

Washing the Underside of the Mower

Instructions for cleaning the mower deck underside after use.

Storage

Cleaning and Storage Procedures

Steps for preparing the machine for storage and general cleaning.

Troubleshooting

Engine Performance Issues

Resolving issues like overheating, starting failures, and power loss.

Starting and Drive System Issues

Troubleshooting starter, engine running, and machine drive problems.

Troubleshooting Other Issues

Abnormal Vibration and Uneven Cutting

Resolving issues related to machine vibration and uneven grass cutting.

Blade Rotation Problems

Diagnosing and fixing issues where mower blades do not rotate.

Schematics

The Toro Warranty

Warranty Coverage and Exclusions

Details warranty periods, covered products, and items/conditions not covered.

Owner Responsibilities and General Conditions

Outlines owner's duties and general terms of the Toro warranty.

Related product manuals

Toro TimeCutter 74760

64 pages

Toro TimeCutter 74766

64 pages

Toro TimeCutter 74768

Toro 74766 User Manual

Table of Contents

Questions and Answers:

Toro 74766 Specifications

Summary

Introduction

Model and Serial Number Plate

Safety

General Safety Guidelines

Slope Indicator

Safety and Instructional Decals

Product Overview

Controls

Controls Operation

Motion-Control Levers

Smart Speed™ Control System

Height-of-Cut Lever

Attachments and Accessories

Operation

Before Operation Safety

Recommended Fuel

Fuel System Maintenance

Using Fuel Stabilizer/Conditioner

Filling the Fuel Tank

Engine Maintenance

Checking Engine-Oil Level

Breaking in a New Machine

Safety-Interlock System

Safety-Interlock System Operation

Testing the Safety-Interlock System

Positioning the Seat

Adjusting the Motion-Control Levers

Adjusting Lever Height

Adjusting the Tilt

During Operation Safety

Operating the Mower Blade-Control Switch (PTO)

Engaging the PTO Switch

Disengaging the PTO Switch

Operating the Throttle

Operating the Choke

Operating the Ignition Switch

Starting and Shutting Off the Engine

Starting the Engine

Shutting Off the Engine

Driving Forward and Backward

Smart Speed™ Control System Usage

Trim Speed Setting

Tow Speed Setting

Mow Speed Setting

Stopping the Machine

Adjusting the Height of Cut

Adjusting the Anti-Scalp Rollers

Using the Side Discharge

Operating Tips

Mowing Best Practices

Keeping the Underside of the Mower Clean

Maintaining the Blade(s)

After Operation Safety

Pushing the Machine by Hand

Transporting the Machine

Loading and Securing the Machine

Maintenance

Recommended Maintenance Schedule

Pre-Maintenance Procedures

Maintenance and Storage Safety

Raising the Seat

Lubrication

Greasing the Bearings

Engine Maintenance

Engine Safety

Servicing the Air Cleaner

Servicing the Engine Oil

Checking the Engine-Oil Level

Changing the Engine Oil and Oil Filter

Servicing the Spark Plug

Removing and Checking the Spark Plug

Installing the Spark Plug

Cleaning the Cooling System

Fuel System Maintenance

Replacing the In-Line Fuel Filter