g017303
Figure 27
1. Bypass-lever locations
3. Lever position for pushing
the machine
2. Lever position for
operating the machine
6. When nished, turn the key to the STOP position to
avoid draining the battery charge.
Note: If the machine fails to move, the electric brake
may still be engaged. You can release the electric brake if
necessary; refer to Releasing the Electric Brake (page 38).
Operating the Machine
Move the bypass levers rearward through the key hole and
down to lock them in place as shown in Figure 27.
Note: Do this for each lever.
Transporting the Machine
Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all necessary brakes,
lighting, and marking as required by law. Please carefully read
all the safety instructions. Knowing this information could
help you, your family, pets, or bystanders avoid injury.
WARNING
Driving on the street or roadway without
turn signals, lights, reective markings, or a
slow-moving-vehicle emblem is dangerous and can
lead to accidents, causing personal injury.
Do not drive the machine on a public street or
roadway.
1. If you are using a trailer, connect it to the towing
vehicle and connect the safety chains.
2. If applicable, connect the trailer brakes.
3. Load the machine onto the trailer or truck.
4. Shut off the engine, remove the key, set the brake, and
close the fuel valve.
5. Tie down the machine near the front caster wheels and
the rear bumper (Figure 28).
g027708
Figure 28
25
To Next Page
Loading...
