Toro 79412 - Using the Draw Bar; Operating Tips

The bagger can be removed by repeating the Setup
sections from all installed bagger related kits in
reverse order . If weights are installed, always remove
the front bagger weights when removing the bagger
attachments.
Note: When switching back to side discharge mode,
remove the bagging baf e and install the original
cutof f baf e and side-discharge chute that came with
the machine.
Using the Draw Bar
The bagger support bracket has a draw bar feature
that can be used for towing.
• Read and understand all the operating instructions
of the machine.
• When turning, slow down and observe the
clearance.
• Make wide turns and keep towed equipment clear
of the towing vehicle.
• Excessive draw bar pull may cause hydrostatic
transmission failure.
g300210
Figure 45
1. Bagger-support bracket with draw bar
Operating T ips
T ips for Bagging
Remembering the Size
Remember that the machine is longer and wider with
this attachment installed. By turning too sharply in
conned places you may damage the attachment.
T rimming
Always trim with the left side of the mower . Do not trim
with the right side of the mower because you could
damage the bagger chute and discharge tube.
Cutting Height
Do not set the mower cutting height too low because
long grass surrounding the mower can prevent air
from getting under the mower and entering the
bagging system. If enough air does not get under the
mower , the bagging system will plug.
Cutting Frequency
Cut the grass often, especially when it grows rapidly .
Y ou will have to cut your grass twice if it gets
excessively long.
Cutting T echnique
For best lawn appearance, be sure to slightly overlap
the mower into the previously cut area. This helps
reduce the load on the engine and reduces the chance
of plugging the chute and discharge tube.
Bagging Speed
Most often you will bag with the mower throttle in the
Fast position and drive at a normal ground speed.
However , in extremely dry and dusty grass, you may
want to slightly reduce the throttle speed and increase
the ground speed of the mower . The bagging system
may plug if you drive too fast and the engine speed
gets too slow . On hills it may be necessary to slow
the mower ground speed. This helps maintain the
engine speed and bagging ef ciency . Mow downhill
whenever possible.
22