10
Weather Sensor Menu
CURRENT ADJUST ---
TEMPERATURE 81
°
F
RAIN STATUS DRY
29
°
F
DRYOUT DAYS 02
SENSORS
→
FREEZE OFF AT
Current Adjust
e percentage that the weather sensor is going to adjust the
irrigation runtime. Possible values range between OFF and
+150; in the majority of cases, the values will display between
±35%. For example, if the evapotranspiration (ET) historical
data calls for a hot season, but the week has in fact been
cloudy, the “Current Adjust” might show "-20%" to reect the
decreased runtime. It can also display OFF.
Temperature
Displays the current temperature at the sensor location.
Temperature unit (Celcius or Farenheit) can be changed in the
controller preferences settings (see the EVOLUTION® user
manual).
Rain Status
Displays the state of the rain sensor: DRY or WET.
Freeze O
e temperature at which irrigation will be turned o due to
cold temperatures. Selections range from 29°- 45°F in 2 degree
increments. is feature can also be toggled to "OFF".
1. Press or to raise or lower the temperature value,
or turn feature o.
2. Press to input the value.
It is possible to disable the Freeze O feature.
Lowering the temperature past 29°F will show OFF.
Press the to input the value.
Dryout Days
After a rain, it is not always necessary to resume irrigation right
away. Setting a Dryout Days period, from zero to 14 days,
delays the automatic resumption of irrigation.
1. Press or to increase or decrease the number of
days to “dryout”.
2. Press to input the value.
Water Adjust
Water Adjust allows the runtime of all stations in all schedules
to which the Weather Sensor has been assigned to be adjusted
by a maximum of ±35%. For example, if the programmed
runtime for station 1 is 10 minutes, setting a Water Adjust of
+35% would adjust that run time to 13 minutes, 30 seconds.
is is useful for seasonal changes.
To Next Page
Loading...
Need help?
General
