Toro EVOLUTION Series - Installation; Smart Connect; The SD Card Explained; Adding the Sensor to the Controller

4
EVOLUTION® Smart Connect®
SD Card Explained
e supplied SD card contains forty years of weather data
for all latitudes, longitudes, and zip codes in North America.
When the weather sensor's location is entered in the controller
(page 6), historical weather data is loaded into the controller.
In the event your controller loses connectivity to the weather
sensor, the controller will use the the historical weather data to
determine the irrigation run time until connectivity is restored.
Adding the Sensor to the Controller
For the EVOLUTION® controller to communicate with
the weather sensor, the sensor (with its unique ID) must be
“added” to the controller.
(For assistance with menu navigation, please see the "Menu
Navigation" section on page 9.)
1. Press ADVANCED then .
2. to ADD/REMOVE DEVICE. to conrm.
ZONE DETAILS
SCHEDULE STARTS
SCHEDULE DETAILS
SENSORS
ADVANCED
→
ADD/REMOVE DEVICE
→
Installation
4
5
3
2
1