Greensmaster Flex 1800/1820/2100/2120 Page 7 − 17 Cutting Unit
3. Slide bedbar adjuster shaft (item 4) into flange bush-
ings in cutting unit side plate. Secure adjuster shaft with
wave washer (item 8) and retaining ring (item 9).
NOTE: Bedbar adjuster shaft (item 4) has left−hand
threads.
4. Apply antiseize lubricant to threads of bedbar adjust-
er screw that fit into adjuster shaft. Thread bedbar ad-
juster screw (item 10) into adjuster shaft.
5. Install bedbar (see Bedbar Installation in this sec-
tion).
6. Install washer (item 11), spring (item 2) and lock nut
(item 3) onto adjuster screw. Tighten the lock nut on
each bedbar adjuster assembly until the compression
spring is fully compressed, then loosen lock nut 1/2 turn.
7. Adjust cutting unit (see Cutting Unit Operator’s
Manual).
1. Crossmember
2. Detent
3. Cap screw
Figure 26
1
23
Flex 1800/1820 Shown
Cutting Unit
To Next Page
Loading...
