Toro Greensmaster Flex 1820 - Clutch Assembly Service (1820;2120)

Greensmaster Flex 1800/1820/2100/2120Traction and Reel Drive System Page 4 - 42
Clutch Assembly Service (1820/2120)
Figure 50
1. Washer head screw (8 used)
2. Clutch cover
3. Gasket
4. Oil seal
5. Clutch shaft assembly
6. Socket head screw (3 used)
7. Locator pin
8. Clutch housing
9. Plug - drain (with magnet and O- ring)
10. Plug - check hole (with O- ring)
11. Spring anchor
12. Jam nut
13. Oil seal
14. Bushing
15. Actuator plug
16. O- ring
17. Actuator pin
18. Breather vent
19. Vent adapter
20. Rubber washer
2
6
8
9
10
1
5
7
4
3
11
13
12
14
15
16
17
18
19
20
9to11ft-lb
(12to14N-m)
See text for
tightening
procedure
9to11ft-lb
(12 to 14 N- m)
See text for
tightening
procedure
The following procedure can be used to remove the
clutch shaft assembly from the clutch. If the clutch shaft
assembly requires service, see Clutch Shaft Service in
this section.
Disassembly (Fig. 50)
1. Remove clutch assembly from transmission housing
(see Transmission Clutch System in this section).
2. Drain lubricant from transmission.
3. Remove eight (8) washer head screws that secure
clutch cover to c lutch housing. Carefully separate and
remove cover from housing. Remove and discard gas-
ket.
4. Using two wrenches, retain spring anchor (item 11)
and loosen jam nut (item 12). Remove spring anchor
and jam nut from actuator pin.