Greensmaster Flex 1800/1820/2100/2120Traction and Reel Drive System Page 4 − 28
Transmission Drive Belt
Figure 34
1. Transmission assembly
2. Transmission belt
3. Gasket
4. Wave washer
5. Transmission cover
6. Key
7. Drive shaft wire
8. Telescoping coupler
9. Washer head screw (2 used)
10. Coupler guard
11. Coupler
12. Set screw (2 used)
13. Washer head screw (7 used)
FRONT
RIGHT
2
3
6
8
9
10
1
5
7
4
11
12
See text for
tightening
procedure
Lubricant
Antiseize
60 to 65 in−lb
(6.8 to 7.3 N−m)
13
Transmission removal from the machine is not neces-
sary to service the transmission drive belt. The trans-
mission drive belt can be replaced by removing the
engine from the frame, removing the transmission cover
and then removing the drive belt.
Drive Belt Removal (Fig. 34)
1. Park machine on a level surface. Make sure engine
is OFF.
2. Remove engine from machine (see Engine Removal
in the Service and Repairs section of Chapter 3 − En-
gine).
3. Use tips of needle nose pliers to spread ends of drive
shaft wire (item 7) in telescoping coupler (item 8). With
wire ends spread, slide coupler from transmission shaft.
4. Remove coupler guard (item 10) from transmission.
5. Loosen two (2) set screws (item 12) that secure cou-
pler (item 11) to transmission shaft. Slide coupler from
transmission shaft. Locate and retrieve key (item 6).
IMPORTANT: During disassembly, make sure that
tension is released from transmission belt before
removing transmission cover.
6. Remove tension on transmission belt by rotating the
engage/disengage shaft clockwise (see Transmission
Belt Tensioner in the General Information section of this
chapter).
7. Remove seven (7) washer head screws that secure
transmission cover to transmission. Carefully remove
cover from transmission. Remove and discard gasket
(item 3).
To Next Page
Loading...
