Toro Greensmaster Flex 1820 - Page 191

RemovingtheIdlerAssembly(continued)
5.Inspecttheshields,bearing,andbushingintheidlerassembly.Removeand
discardthecomponentsthatarewornordamaged.
InstallingtheIdlerAssembly
1.Iftheshields,bearing,orbushingwasremovedfromtheidlerarm,install
newcomponentsasfollows:
A.Pressthebushingintoagroomerplateuntilthebushingiscenteredin
theidlerarmbore.
B.Pressthebearingintotheidlerarmsothatthebearingcontactsthe
shoulderinidlerarmboreandinstallthebearingretainingring.
C.Installthebearingshieldswithockedsideofshieldtowardthebearing.
D.Checktheidlerarmorientationandinsertthestubshaftthroughshields
andbearing.Usethethroughholeintheshafttopreventshaftfrom
rotating,tightentheangenutto37to45N∙m(27to33ft-lb).
E.Ifthecollarwasremovedfromtheidlerarm,installthecollarandtighten
to33to41N∙m(24to30ft-lb).
2.Applyanti-seizelubricanttotheinsidediameteroftheidlerarm.
3.Installanewcotterpinandclevispinandsecuretheheightadjustmentrod
tothefrontoftheidlerarm.
4.Installreeldriveassembly,reelpulley,reeldrivebeltandthenreeldrive
covertoleftsideofcuttingunit(seeReelDriveAssemblyintheServiceand
RepairssectionofChapter4-TractionandReelDriveSystem).
GreensmasterFlex1800/1820/2100/2120
Page9–17
UniversalGroomer(Optional):ServiceandRepairs
12188SLRevD