Groundsmaster 3500Hydraulic System Page 5 − 52
12.Hold disconnected motor case drain hose into a con-
tainer graduated in ounces or milliliters (e.g. Toro
#TOR4077) and collect hydraulic fluid for 30 seconds.
After 30 seconds, remove hose end from container.
13.Record amount of fluid collected in the container.
14.Disengage cutting decks, set throttle to low speed
and stop engine.
15.If volume is more than 80 oz (2366 milliliters), repair
or replace the tested deck motor.
16.Remove tester and reconnect hydraulic hoses.
17.Check hydraulic fluid level (see Traction Unit Operat-
or’s Manual).
18.Repeat test with remaining deck motors as needed.
19.Install deck motors after testing is completed. (see
Cutting Deck Operator’s Manual). Tighten mounting
screws from 33 to 36 ft−lb (3.7 to 4.0 N−m).
To Next Page
Loading...
