Groundsmaster 3500Page 6 − 2Electrical System
General Information
Operator’s Manual
The traction unit Operator’s Manual provides informa-
tion regarding the operation, general maintenance and
maintenance intervals for your Groundsmaster ma-
chine. Refer to the Operator’s Manual for additional in-
formation when servicing the machine.
Electrical Drawings
The electrical schematic and wire harness drawings for
the Groundsmaster 3500−D Model 30807 and the
Groundsmaster 3500−G Model 30809 are located in
Chapter 9 − Foldout Drawings.
Standard Control Module (SCM)
All Groundsmaster 3500 machines with are equipped
with a Standard Control Module (SCM) to monitor and
control electrical components required for safe opera-
tion. The SCM can be used to check operation of ma-
chine switches by monitoring the SCM LED’s. Detailed
information on the Standard Control Module can be
found later in this chapter.
Kubota Diesel Engine − Electrical Components
The engine used in the Groundsmaster 3500−D incor-
porates the following electrical components to start and
run properly:
Glow plug controller and relay
Fuel stop Solenoid
High Temp Warning and Shutdown Switches
Oil Pressure Switch
Alternator
Additional information on troubleshooting and servicing
engine electrical components can be found in the appro-
priate Kubota Workshop Manual.
Figure 1
To Next Page
Loading...
