Groundsmaster 3500 Page 7 - 15 Wheels, Brakes,and Chassis
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Remove control panel cover from the machine.
IMPORTANT: When removing the adjustable clevis,
adjustment rod, or the brake lever, make sure to
mark both parts. Marking both parts will make reas-
sembly and brake adjustment easier.
3. Remove and replace parts as necessary to repair
brake linkages.
4. Install control panel cover to the machine.
IMPORTANT: Always check and adjust brakes any-
time brake linkages are disassembled or repaired.
Wheels, Brakes,
and Chassis
To Next Page
Loading...
