Groundsmaster 3500Cutting Decks Page 8 − 2
Specifications
MOUNTING: All cutting units are supported by equal
length, independent lift arms and are interchangeable to
all three cutting unit positions.
CONSTRUCTION: Deck chamber and frame are
welded steel construction reinforced with channels and
plates.
HEIGHT−OF−CUT RANGE: 3/4 to 4 inch (19 to 101
mm) in 1/4 inch (6.4 mm) increments. Height−of−cut ad-
justment is made by repositioning deck on deck frame.
DECK DRIVE: Closed loop, integrated relief, hydraulic
system operates cutting deck hydraulic motors. Blade
spindles are 1−1/4 inch (31.7 mm) shafts supported by
greaseable, tapered roller bearings in a ductile iron
housing.
CUTTING BLADE: Each cutting deck equipped with a
27 inch (686 mm) length, 0.250 inch (6.4 mm) thick, heat
treated, steel blade. Anti−scalp cup installed on cutting
blade. The standard blade is optimized for most cutting
applications. Optional high lift, angled sail and Atomic
blades are available for those situations where the stan-
dard blade is not ideal.
DISCHARGE: Clippings are discharged from the rear of
the mowing decks. Pre−drilled mounting holes allow at-
tachment of optional mulching baffle.
CUTTING DECK LIFT: Cutting decks are controlled
with one (1) lift lever.
SUSPENSION SYSTEM: A fully floating suspension
with hydraulic counterbalance. Main center pivot allows
side−to−side deck oscillation. Individual decks sup-
ported with two (2) front rollers and one, full width, rear
roller.
WEIGHT: Individual cutting deck weighs approximately
195 lb (89 kg).
To Next Page
Loading...
