Toro Groundsmaster
3500-D - Page 130

Groundsmaster 3500--DHydraulic System (Rev. D) Page 4 -- 82
Hydraulic Manifold Service (Serial Number Below 240000600)
1. Manifold body
2. Logic cartridge valve (LC1)
3. Seal kit
4. Braking cartridge valve (BV)
5. Seal kit
6. SRV cartridge valve (R1)
7. Seal kit
8. SRV coil
9. Nut
10. Plug (SAE--2)
11. O --ring
12. Plug (SAE--4)
13. O--ring
14. Plug (SAE--8)
15. O--ring
Figure 55
1
4
8
10
9
FRONT
RIGHT
30 to 35 Ft--lb
(41to47N--m)
30 to 35 Ft--lb
(41to47N--m)
30 to 35 Ft--lb
(41to47N--m)
Loctite 242
4to6Ft--lb
(5 to 8 N--m)
12
12
12
10
10
10
10
10
10
11
11
11
13
11
11
11
11
13
13
6
2
7
3
5
14
15
Note: The ports on the manifold are marked for easy
identification of components. Examples: BV is the deck
circuit braking valve and P1 is the gear pump c onnection
port. (See Hydraulic Schematics to identify the function
of the hydraulic lines and cartridge valves at each port
location).
SRV Cartridge Valve ( Fig. 55 and 56)
1. Make sure the manifold is clean before removing the
cartridge valve.
2. Remove nut securing solenoid to the SRV cartridge
valve. Slide solenoid off the valve.
IMPORTANT: Use care when handling the cartridge
valve. Slight bending or distortion of the stem tube
can cause binding and malfunction.
3. Remove SRV cartridge valve from port R1 using a
deep socket wrench.