Toro Multi Pro 5800 - Removing the Shipping Bumper

Figure3
1.Boomhingespring2.Jamnut
4.Repeattheprocedureforeachspringonbothboom
hinges.
5.Movetheboomsintothetransport“X”position;refer
toOperatingtheBooms(page32).
2
RemovingtheShipping
Bumper
NoPartsRequired
Procedure
1.Removethebolts.washers,andnutsthatsecurethe
shippingbumpertothefrontchassisplate(Figure4).
Figure4
1.Nut3.Washer
2.Shippingbumper
4.Bolt
2.Removetheshippingbumperfromthemachine
(Figure4).
Note:Discardthebolts.washers,nuts,andshipping
bumper.
15