Toro Power Max 826LE - Replacing Headlight Bulb; Storage Precautions

www .T oro .com for additional ser vice infor mation or ha v e
an A uthorized Ser vice Dealer re place the belt.
Replacing the Headlight Bulb
Use a GE 892 16W halo gen light bulb . Do not touc h the
bulb with y our hands or allo w dir t or moisture to come into
contact with the bulb .
1. R emo v e the wire connector from the bac k of the
headlight ( Figure 50 ).
Figure 50
2. T ur n the base of the bulb countercloc kwise until it
stops ( Figure 51 ).
Figure 51
3. R emo v e the bulb straight out from the bac k of the
headlight ( Figure 52 ).
Figure 52
4. Inser t a new bulb into the bac k of the headlight ( Figure
53 ).
Figure 53
5. T ur n the base of the bulb cloc kwise until it is sn ug
( Figure 54 ).
Figure 54
6. Inser t the wire connector straight into the bac k of the
headlight until it is securely in place ( Figure 55 ).
Figure 55
Storage
• Gasoline v apor s can explode.
• Do not stor e gasoline mor e than 30 days.
• Do not stor e the sno wthr o w er in an enclosur e
near an open flame.
• Allo w the engine to cool bef or e storing it.
Preparing the Snowthrower
for Storage
1. On the last refueling of the year , add fuel stabilizer to
fresh fuel as directed b y the engine man ufacturer .
2. R un the engine for 10 min utes to distribute the
conditioned fuel through the fuel system.
3. Loosen the hose clamp that secures the fuel line to the
v alv e and slide the fuel line off the fuel shutoff v alv e .
4. Open the fuel shutoff v alv e and allo w the fuel to drain
out of the fuel tank into an appro v ed fuel container .
19