Toro Pro Control XP - Initial Field Testing

InitiallyField-testingthe
System
Beforeoperatingthespraysystem,performthis
procedure.
1.Drivethevehicleatthedesiredsprayingspeedwith
thesprayerboomsoff.
2.Pressthe[Speed]keytoverifythespeedreadout.
3.TurntheSpraypumpcontrolswitchtoOn.
4.TurntheProControlXPPowerswitchtotheOn
position.
5.TurntheFootswitchtotheOnposition.
Note:UsetheFootswitchwhenalltheboomsare
tobeturnedon.
6.EnsurethattheBoom1,Boom2,andBoom3
switchesareintheOnposition.
7.SettheMan/RateswitchtoRate1.
8.Increaseordecreasethevehiclespeedby1mph(2
km/h).
Note:Thesystemshouldautomaticallycorrect
thetargetapplicationrate.Ifthesystemdoesnot
correcttheapplicationrate,reviewtheInitialSystem
Setup;thenrefertoTroubleshooting.
9.Aftersprayingaswath,switchthefootswitchtothe
Offpositiontoshutoffthesprayowtoallbooms.
Note:Thisalsoshutsofftheareacalculations.
10.Verifytheareacoveredandthevolumeofmaterial
sprayed.
13