Toro Pro Force Groundsmaster 3280-D - Installing the Drive Shaft to the Blower Gearbox Shaft; Installing the Mounting Plate to the Debris Blower Frame

12.Installabolt(1/2–13x3/4inches),alockwasher
(1/2inch),andaatwasher(9/16x1–3/8
inches)tothetopofeachsupportrod(Figure3).
13.Turnoffthetractionunit.
14.AttachtheCVshafttotheshaftandsecure
itwitharollpin(3/16x2–1/4inches),2bolts
(3/8–16x1–3/4inches),and2locknuts(3/8–16
inch).
15.Torquetheboltsandlocknutsto37to44N⋅m
(27to33ft-lb).
4
InstallingtheDriveShaftto
theBlowerGearboxShaft
Partsneededforthisprocedure:
1
Drive-shaftassembly
1Rollpin
2
Bolt(5/16x1-3/4inches)
2
Locknut(5/16inch)
Procedure
1.Removethecabletiesecuringthedriveshaft
totheshippingcrate.
2.Slidethedriveshaftontothegearboxshaft.
g023911
Figure4
1.Rollpin(3/16x1–1/2
inches)
4.Bolts(5/16x1–3/4inches)
2.Safetychain5.Locknuts(5/16inch)
3.Driveshaft6.Gearboxshaft
3.Alignthemountingholesinthegearboxshaft
withtheholesinthedriveshaftandslidethem
together.
4.Securethemwitharollpin(Figure4).
5.Securethedriveshafttothegearboxshaftwith
2bolts(5/16x1–3/4inches),2locknuts(5/16
inch),andarollpin(3/16x1–1/2inches)as
showninFigure4.
6.Torquetheboltsandlocknutsto18to25N⋅m
(175to225in-lb).
7.Removethecabletiethatholdsthedriveshaft
together.
8.Securethesafetychaintotheblowerframe
(Figure4).
5
InstallingtheMounting
PlatetotheDebrisBlower
Frame
Partsneededforthisprocedure:
1Mountingplate
4
Bolt(1/2x1-1/4inches)
4
Locknut(1/2inch)
Procedure
1.Removetheboltssecuringthemountingplate
tothecrate(Figure5).
g021682
Figure5
1.Mountingplate
2.Installthemountingplatetothedebrisblower
framewith4bolts(1/2x1-1/4inch)and4
locknuts(1/2inch)asshowninFigure6.
5