REELMASTER® 335-D and 3500-D Maintenance Schedule
Minimum Recommended Maintenance Intervals:
Maintenance Procedure Maintenance Interval & Service Type:
Every
Every
Every
Every
800hrs
Every
400hrs
200hrs
Inspect Air Filter, Dust Cup, and Baffle 100hrs
50hrs
Lubricate All Grease Fittings
A Level
Service
‡ Change Engine Oil & Filter
Check Battery Level and Connections
B Level
Inspect Cooling System Hoses
Service
Service Air Cleaner Filter Element
Inspect Cutting Unit Reel Drive Belts C Level
† Torque Wheel Lug Nuts
Service
Replace Fuel Filter
Check Front Transaxle Oil level
Check Rear Axle Oil level (4WD)
Inspect Fuel Lines and Connections D Level
‡ Check Engine RPM (idle and full throttle)
Service
Inspect Engine Fan Belt
Inspect Engine Timing Belt
(see note below)
Drain and Clean Fuel Tank
Change Hydraulic Oil
‡ Replace Hydraulic Oil Filter
Change Front Transaxle Oil
Pack Rear Axle Bearings (2WD)
Change Rear Axle Oil (4WD) E Level
Check Rear Wheel Toe-in
Service
† Initial break in at 10 hours
‡ Initial break in at 50 hours
Replace Moving Hydraulic Hoses
Annual Recommendations:
Replace Safety Switches
Items listed are recommended every 1500 hours
or
2 years whichever occurs first.
Cooling System - Flush/Replace Fluid
See Operator's and Service Manual for specifications and procedures)
NOTE: Replace Timing Belt if worn, cracked or oil soaked. A new Timing Belt should be installed
any time the Belt is removed or loosened.
To Next Page
Loading...
