Toro Revolution Series - Adjusting the Tilt; Calibrating the Levers

AdjustingtheTilt
1.Parkthemachineonalevelsurface,disengage
theblade-controlswitch(PTO),andmovethe
motion-controlleversoutwardtothePARK
position.
2.Shutoffthemachine,removethekey,andwait
forallmovingpartstostopbeforeleavingthe
operatingposition.
3.Loosentheupperboltholdingthecontrollever
tothecontrolarmshaft.
4.Loosenthelowerboltjustenoughtopivotthe
controlleverforeoraft.Tightenbothboltsto
securethecontrolinthenewposition.
g401470
Figure69
5.Repeattheadjustmentfortheoppositecontrol
lever.
g009195
Figure70
CalibratingtheLevers
Note:TheInfoCenterdisplaysonly2itemsatatime;
however,thefollowingguresshowthefullmenus
forcontext.
1.Parkthemachineonalevelsurface,disengage
thePTO,andmovethemotion-controllevers
outwardtothePARKposition.
2.Enableaccesstoprotectedmenus;referto
AccessingProtectedMenus(page17).
3.IntheMAINMENU,scrolldowntoSERVICEand
pressthe
button.
g376300
Figure71
4.IntheSERVICEmenu,scrolldowntoLEVER
CALIBRATIONandpressthe
button.
g425329
Figure72
5.Followthepromptsonthescreen.Pressthe
buttonaftereachstep;toexitcalibration,press
theExitbutton.
Screen
Action
Pressthebutton.
Holdtheleftmotion-control
leverinthefullFORWARD
positionandpressthe
button.
44