Toro TC 1000 - Page 7

Service Procedures (continued)
j
Section 3 Ignition Page
operation 23
air gap adjustment 25
coil removal 26
coil installation 26
Section 4
Recoil Starter
Recoil Starter
operation 27
removal 27
installation 27
reel disassembly 27
reel reassembly 28
starter pulley disassembly 29
starter pulley reassembly 29
Section
5 Clutch
Clutch Shoes and Flywheel
operation 30
inspection 30
removal
30
reassembly 31
Clutch Drum and Clutch Housing
disassembly 31
reassembly 31
Section 6
Engine
operation 32
removal from drive tube 34
disassembly 35
cleaning after disassembly 36
inspection 37
reassembly 38
installation on drive tube 39
Section 7
Controls
Control and Grip
removal from drive tube 40
installation on drive tube 40
Section 8
Handle
removal from drive tube 41
installation on drive tube 41
adjustment 41
Section 9 Shield
knife replacement 42
removal from drive tube 42
installation on drive tube 42